siding

Back

real cedar siding
introduction

Back

siding home
why real cedar?
western red cedar characteristics
sustainability
design & spec

Back

siding profiles
bevel siding
board and batten siding
t&g siding
lap or channel siding
trim boards
shingle panels
building

Back

preparation for installation
pre-building tips
dupont™ tyvek® drainwrap™
installation
general installation
installing profiles
bevel
board & batten
tongue & groove
lap or channel
trim boards
shingle panels
finishing

Back

how to finish
types of finishes
care & maintenance
restoration
decking

Back

real cedar decking
introduction

Back

decking home
why real cedar?
western red cedar characteristics
sustainability
planning

Back

decking calculator
deck projects
roof deck
raised deck
ground level deck
uphill sloping lot deck
building

Back

fastener recommendations
stair & railing installation
finishing

Back

finishing tips
restoration
care & maintenance
outdoor

Back

real cedar outdoor
introduction

Back

outdoor home
why real cedar?
western red cedar characteristics
sustainability
design & spec

Back

real cedar free diy project plans
design tips
building

Back

project preparation
outdoor fasteners
fence construction
fence specifications
prebuilt fence panels
finishing

Back

finishing techniques
finishing tips
restoration tips
project care & maintenance
indoor

Back

western red cedar indoor
introduction

Back

indoor home
why real cedar?
western red cedar characteristics
sustainability
planning

Back

cedar saunas
traditional saunas
infrared cedar sauna
cedar indoor design tips
building products

Back

building preparation
indoor t&g paneling
doors & windows
blinds & shutters
finishing

Back

finishing tips
care & maintenance
timbers

Back

western red cedar timbers
introduction

Back

timbers home
why real cedar?
western red cedar characteristics
sustainability
planning

Back

grades and specifications
building

Back

preparation
installation
maintenance

Back

finishing
restoring western red cedar timbers
care & maintenance
gallery
resources
for architects and builders

New Zealand

Fasteners for Outdoor Projects

Recommended Fasteners

Cedar Arbor Painted OrangeLarge members require timber connectors other than nails. Bolts, lag screws, split rings and shear plates, and custom made hardware are commonly used in heavy timber structures where the joint’s strength must be greater than that which could be achieved with nails. These types of connectors should be corrosion-resistant or suitably coated to prevent corrosion and staining. Generally, the design of mechanically fastened joints must take into consideration a variety of factors such as end and edge-spacing distances, moisture content, service conditions, and the effect of the number of connectors used. Because the cost of fabricating and installing connections may amount to a large percentage of the cost of a heavy timber structure, it is important to engineer the details of a structure before designing the timber members.

Screws can be used to fasten decks. Double hot-dipped galvanized screws can be used, however, stainless steel screws are recommended. For most applications a 304 (18-8) grade provides adequate corrosion resistance. For decks exposed to salt air, use 316 grade. Screws must be long enough to penetrate 1″ (25 mm) into support members. Penetration of 1-1/4″ is required for structural components.

Blind fastening systems create an attractive, fastener-free deck surface. They employ metal clips and/or joist top brackets that fasten the sides or bottom of the deck board to the joists so that no fasteners are visible. Blind fastening systems are the ideal complement to the beauty of Western Red Cedar decking.

Why Western Red Cedar
Find out where to buy
Gallery